Hello!
I really want to help with this project but keep finding it increasing frustrating when my work units don't complete.
I run Boinc with a total of 3 projects. The other two never give me any issue.
Rosetta, unfortunately does.

I find that the "disk space" used by the Rosetta work loads are consistently 10-100 times larger in size than the other two projects. Not that that is a problem but it does make me wonder!
With this larger size, there is an associate dramatic increase in the time it takes for each work load to finish. See included screen shot.
Not that that is an issue either.

However, what is SO frustrating is when these units take SO long to complete and finally, never do, I'm at a point where I want to just remove this project!
Oh ... also, your time allowed for these units is also much shorter than others ... again, see screen shot.

I do want to lend you my help and assistance if at all possible as this is such a good cause to do so! But unfortunately, up to now, my "help" to the project has been very near nil ! I only imagine that others are also have these problems as well.

Any thoughts or suggestions on what I can do to be more productive for your project would be greatly appreciated.

Sincerely,
Chris Barbot

ps .... how can I send you a screen shot?? I can't seem to past it into this communication / email ...

[img][/img]